6
Important
When the operating knob is left at the end of the starting time (see rating plate and instruc-
tion manual), this must move up about 5 mm and return to is starting height. If this does not
happen, shut the gas valve and contact your aftersales service centre.Do noy let the item
work with the operating knob pressed downwards by force.
VENTILATED CATALYTIC HEATER
Electrical connection
- Before using the appliance check that your supply voltage is the same as that shown on
the rating label of the unit.
- Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.
- THIS APPLIANCE COMPLIES WITH THE EEC DIRECTIVE 89/336, relating to electro-
magnetic compatibility.
OPERATION AND USE
Fully insert plug into socket-outlet and switch on the fan heater following the instructions below.
Before switching on the gas burner, read carefully the relevant operating instructions.
IMPORTANT
DO NOT cover the appliance when in operation, this could cause a dangerous rise of the
temperature of the fan heater with consequent risk of fire.
Important notes
-
Your heater must always be earthed: warranty does not cover damages caused by non-
observance of this warning.
-
Do not use your heater close to wash-basin, bath- tub, shower, swimming pool.
- Do not lay the cable on the hot unit.
-
Use the appliance only standing on the floor.
- The heater must always operate in upright position.
-
Do not cover either the hot air output or input grid on
the top of the unit during service.
-
Replacement of the power cable must be carried out
by qualified personnel. Always use original spare
parts supplied by the manufacturer.
-
The heater must not be located immediately below a
fixed socket outlet.
.- Never direct the fan hater’s air flow towards furniture,
curtains , spray cans and inflammable material.
-
Do not install the appliance in a room which might
contain gas, oil or sulphur, or near sources of heat.
-
The appliance should not be used in high mountains.
Fig. 6
573441 GB 31-01-2001 14:34 Pagina 6
