11
1. After connecting the gas supply, check the piping and connections for leaks using
a soap and water solution. The presence of bubbles indicates a leak, tighten or
replace connections as appropriate.
Warning:
Do not use any naked flame to check for leaks.
2. Adjust the test point pressure or supply pressure to the value which is appropriate
for the gas type.
3. The operation of the appliance must be tested when installation is completed.
4. Turn on the appliance gas controls and light each burner individually and in combi-
nation. Check for a well defined blue flame without any yellow tipping. If any abnor-
mality is evident then check that the burner cap is located properly and the injector
nipple is aligned correctly.
5. Check the minimum burner setting by quickly rotating the gas control knob from the
maximum to the minimum position, the flame must not go out. If adjustment is
required carry out the “Setting the burner minimum" procedure described.
6. If satisfactory performance cannot be obtained, the installer shall check the instal-
lation and notify the local gas supply authority for a gas supply problem, or if it is
an appliance problem, our Customer Service Centre should be called to obtain the
nearest authorized Delonghi Service Agent.
Figure 1.16
gas pipe
cooker
rear protection
WARNING,
This appliance
IS NOT SUITABLE
for installation with a hose
assembly.
I N S T A L L A T I O N
Summary of Contents for AP 1246 G
Page 56: ...Rif 1688 5...