5. Disassembly and Assembly Procedures
5.2 Assembly Procedures:
Place a bracket chassis base on a protective
cushion, then stick 3pcs Silicon sheets on the
position as the picture below shown.
S2
S1
S4
S3
Panel preparation: Take out 1pcs panel module from
the carton, remove the protective film by tearing off
all the tapes of screen and four sides, then examine
the panel surface according to inspection criteria
carefully. Provide the power source to the panel
module to make sure the panel can be powered on.
S5
Take 1pcs Dell nameplate, then use a locating fixture
to fix the nameplate to the front bezel of the module,
and then move the whole unit into a laminating
fixture, use the laminating fixture to press the
nameplate with the front bezel of the panel module
firmly attachment.
S6
Turn over a power board and put the power board
into the bracket chassis.
Take 1pcs interface board, connect 1pcs LVDS cable
to the interface board, then connect the power board to
the interface board. Turn over the interface board and
locate it into the bracket. Take 1pcs LED driver board
to connect with the power board, turn over the board
and locate it into the bracket. Use a Philips-head
screwdriver to tighten 8pcs screws for locking the
interface board, power board and LED driver board.
(No.1 screw size=M4x8, Torque=7.5
±0.5
kgfxcm;
No.2~8 screw size=M4x8, Torque=7.5
±0.5
kgfxcm)
4
1
3
2
7
6
5
8
Take a black mylar to insert the hooks of the bracket
to cover the power board.
