9.
Disconnect the right power/battery light cable, left power/battery light cable, display cable, and camera cable from the system board connectors.
10.
Remove the display cable screw.
11.
Remove the four screws (two on either side) that secure the display assembly to the computer base.
12.
Lift the display assembly off the computer.
Replacing the Display Assembly
1.
Place the display assembly in position and replace the four screws (two on either side) that secure the display assembly.
2.
Place the right power/battery light cable, left power/battery light cable, display cable, and camera cable in the routing guides and connect them to the
respective system board connectors.
1 right power/battery light cable
connector
2 camera cable connector
3 display cable connector
4 left power/battery light cable
connector
5 Mini-Card antenna cable front
routing
NOTICE:
To avoid damage to the display, you must not disassemble your Edge-to-Edge display assembly in the field.
1 right power/battery cable connector 2 camera cable connector
3 display cable connector
4 display cable screw
5 left power/battery cable connector
6 screws (4 total; 2 on either side)
7 display assembly
NOTICE:
To avoid damage to the display, you must not disassemble your Edge-to-Edge display assembly in the field.
Summary of Contents for Studio XPS 1640
