4. Disassembly and Assembly Procedures
Take 1pcs power board, then connect 1pcs panel
lamp cable to connect with the power board. Turn
over the power board and put it into the bracket.
Place a bracket chassis base on a protective
cushion, then stick 1pcs Silicon sheet on the position
as the picture below shown.
4.2 Assembly Procedures:
S2
S1
S3
Take 1pcs interface board, connect 1pcs LVDS cable
to the connector of the interface board, then connect
the connective cable to the interface board. Turn over
the interface board and locate it into the bracket. Use
a Philips-head screwdriver to tighten 6pcs screws for
locking the circuit board, then locate the panel lamp
cable into the hook of the bracket.
(No.1 screw size=M4x8, Torque=7
±0.5
kgfxcm;
No.2~6 screw size=M3x7.5, Torque=7
±0.5
kgfxcm)
Panel preparation: Take out 1pcs panel module from
the carton, then remove the protective film by tearing
off the tapes, and then examine the panel surface
according to inspection criteria. Turn over the panel,
and then place screen faced down for later
assembling.
S6
3
4
2
1
5
6
Take 1pcs mylar to insert the hooks of the bracket to
cover the power board, then locate the panel lamp
cable into the hook as the picture below shown.
S4
S5
Put the bracket chassis module on the back of the
panel module. Push the earing-locks and then
connect the LVDS cable to the connector of the
panel module.
