4. Disassembly and Assembly Procedures
Locate the function key board with Joystick key to the
specific position of the rear cover, then use a Philips-
head screwdriver to tighten 4pcs screws for locking
the function key board with the rear cover. Tear off the
tape papers on the back of the key cable, and then fix
the key cable with 2pcs tapes. Paste 1pcs shading
tape to cover the diffusion sheet.
(No.1~4 screw size=M2x0.2, Torque=0.8
±
0.2
kgfxcm)
S18
Take 1pcs joystick key and 1pcs function key board,
assemble the joystick key with the function key board,
then press the joystick key to check if it work
normally.
S15
Take 1pcs rear cover, then put the rear cover on a
cushion foam for later assembling. Take 1pcs
diffusion sheet, plug 1pcs LED cable to the connector
of the diffusion sheet .
S16
Move the assembled rear cover with function key
board close to the assembled unit, then connect
function key cable and LED cable to the connectors
of the board. Put down the rear cover and push
the rear cover for mechanisms engagement.
Tear off the tape paper on the back of the panel lamp
cable, then connect the panel lamp to the connector
of the panel, and then fix the lamp cable with tapes.
Connect the touch key cable and power key cable to
the connectors of board. Paste 1pcs aluminum foil to
fix the cover the LVDS connector and cables as the
picture below shown.
S14
Tear off the adhesive tape paper of the diffusion
sheet, then locate and fix the diffusion sheet with LED
cable on the hook of the rear cover.
S17
1
3
4
2
S19
