4–Boot Configuration
iBFT Boot Setup (iSCSI)
4-28
CU0354602-00 A
Figure 4-19. Configuring Target Settings for IPv6 (Static)
10. Press ESC and save the settings.
11.
Reboot the system.
Setting Up a Dynamic IPv6 Address
To set up a dynamic IP address on IPv6, follow these steps:
1.
Start the server and when the NIC boot code banner appears, press
CTRL+Q.
The QLogic CNA Function Configuration utility opens to the Select Adapter
menu.
2.
Select the adapter to configure, and then press ENTER.
The QLogic CNA Function Configuration utility opens to the Setup menu for
the selected adapter.
3.
Under Function Configuration, select the iBFT function to configure, and
then press ENTER.
4.
Under
Adapter Settings
, configure the following, as shown in
Figure 4-20
:
a.
Set
Enable ROM
to
Enabled
.
b.
Set
IP Format
to
IPv6
.
c.
Set the
VLAN Mode
to one of the following:
Disabled
if the VLAN is not used in the network
Enabled
to specify a valid VLAN ID
d.
If VLAN is enabled, specify a valid
VLAN ID
in the range of 2 to 4095.
