Dell Precision 610, Service Manual

Page: 48 / 96

3-6 Dell Precision 610 Mini Tower Systems Service Manual
Alert! Primary
processor is
out of rev.
System detected that
the primary processor is
not the correct revision.
If the system contains
more than 512 MB of
RAM, this message will
be followed by a
Sys-
tem Halted
message.
Processor is a type not
supported by Dell.
Alert! Proces-
sor thermal
probe failure
detected.
Processor or
system board has
failed. Faulty processor or
defective system board.
Alert! Second-
ary processor
is out of rev.
System detected that
the secondary proces-
sor is not the correct
revision. If the system
contains more than
512 MB of RAM, this
message will be fol-
lowed by a
System
Halted
message.
Processor is a type not
supported by Dell.
Alert! Single-
bit memory
error previ-
ously detected
in XXXXh.
Single-bit ECC error
was detected during
the previous operating
session. Faulty or improperly
seated DIMMs or defec-
tive system board.
Alert! System
fan was not
detected.
System fan was not
detected. No fan installed, defec-
tive fan, or fan cable not
connected.
Alert! Unbuf-
fered and
registered
SDRAM DIMMs
cannot be
mixed.
Mixing of unbuffered
and registered SDRAM
DIMMs is not
supported. Two different types
(unbuffered and regis-
tered) of SDRAM DIMMs
have been installed
together and may not be
compatible.
Alert! Uncor-
rectable memory
error previ-
ously detected
in XXXXh.
Multibit ECC error was
detected during the pre-
vious operating session. Faulty or improperly
seated DIMMs or defec-
tive system board.
Auxiliary
Device fail-
ure. Verify
that mouse and
keyboard are
securely
attached to
connectors.
System detected a
mouse failure. Faulty mouse, or faulty
mouse controller or key-
board is attached to the
mouse connector.
7DEOH 6\VWHP (UURU 0HVVDJHV FRQWLQXHG
0HVVDJH 'HILQLWLRQ 3UREDEOH &DXVHV