122
About Your System
TPM configuration
operation is
pending.
Press (I) to
Ignore OR (M) to
Modify to allow
this change and
reset the system.
WARNING: Modifying
could prevent
security
This message is displayed
when the system re-starts
after a TPM configuration
command is entered.
Enter I or M to proceed.
TPM configuration
operation honored.
System will now
reset
TPM configuration
operation command has
been accepted
For information only.
Unsupported CPU
combination.
Mismatched processors are
installed.
Processor is not supported
by the blade.
Replace a processor so that
both processors match. See
"Processors" on page 225.
Check for a BIOS update
using the Dell Support
website at
support.dell.com
.
Unsupported CPU
stepping detected.
Processor is not supported
by the blade.
Check for a BIOS update
using the Dell Support
website at
support.dell.com
.
If the problem persists,
install a supported processor.
See "Processors" on
page 225.
CPU set to minimum
frequency.
The processor speed may
be intentionally set low for
power conservation.
If not an intentional setting,
check any other system
messages for possible causes.
Table 1-26. Blade Messages
(continued)
Message
Causes
Corrective Actions
Summary of Contents for PowerEdge M1000e
