1-12
Ra c k I n s t a l l a t i o n G u i d e
www
.dell.com | support.dell.com
To install the cable-management arm on the back of the system, perform the following
steps:
1
Facing the back of the rack cabinet, locate the latch on the end of the right slide
assembly that you secured to the back vertical rail.
2
Push the tab on the back end of the cable-management arm into the latch on the end
of the slide assembly (see Figure 1-8).
The latch clicks when locked.
3
Push the tab on the front end of the cable-management arm into a mating latch on
the inner segment of the slide assembly (see Figure 1-8).
The latch clicks when locked.
F i g u r e 1 - 8 .
I n s t a l l i n g t h e C a b l e - M a n a g e m e n t A r m
latch on inner segment
of slide assembly
stop block
cable-management arm
latch on end of slide assembly
tab on front end
tab on back end
5X860eb0.fm Page 12 Monday, October 21, 2002 11:49 AM
