Dell PowerConnect J-EX8208, Software Manual

Page: 984 / 3660

Table 123: Port Edit Options (continued)
Your Action Function Field
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
with the interface. Type the
VLAN ID for a new VLAN.
2. Click
Details
to view CLI commands for this role.
3. Click
OK
.
Applies the wireless access point role.
The interface family is set to
ethernet-switching
,
port mode is set to access , and RSTP is enabled
with the edge and point-to-point options.
Wireless Access
Point
To specify an IPv4 address:
1. Select the check box IPv4 address .
2. Type an IP address—for example:
10.10.10.10
.
3. Enter the subnet mask or address prefix. For
example, 24 bits represents
255.255.255.0
.
4. Click
OK
.
To specify an IPv6 address:
1. Select the check box
IPv6 address
.
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334
.
3. Enter the subnet mask or address prefix.
4. Click OK .
Applies the routed uplink role.
The interface family is set to inet , and
recommended CoS parameters are set for
schedulers and classifiers. See Table 124 on
page 914 for more CoS information.
Routed Uplink
1. For this port role you can select a VLAN member
and associate a native VLAN with the interface.
2. Click Details to view CLI commands for this role.
3. Click OK .
Applies the Layer 2 uplink role.
The interface family is set to
ethernet-switching
,
port mode is set to
trunk
, RSTP is enabled with
the
point-to-point
option, and port security is set
to dhcp-trusted .
Layer 2 Uplink
Specifies that no port role is configured for the
selected interface. None
NOTE: See “Port Role Configuration with the J-Web InterfaceCLI Reference” on page 915 for details on the CLI commands that
are associated with each port role.
NOTE: For a J-EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
912
Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS