Dell PowerConnect 8024, User Configuration Manual

Page: 690 / 1294

690
Configuring Port-Based Traffic Control
Configuring Port-Based Traffic Control (CLI)
This section provides information about the commands you use to configure
port-based traffic control settings. For more information about the
commands, see the
PowerConnect 8024/8024F/8132/8132F/8164/8164F CLI
Reference Guide
at support.dell.com/manuals .
Configuring Flow Control and Storm Control
Beginning in Privileged EXEC mode, use the following commands to
configure the flow control and storm control features.
Command Purpose
configure
Enter global configuration mode.
flowcontrol Globally enable flow control.
interface interface
Enter interface configuration mode for the specified
interface. The
interface
variable includes the interface type
and number, for example
tengigabitethernet 1/0/3
.
You can also specify a range of interfaces with the interface
range
command, for example,
interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
storm-control broadcast
[level
rate
]
Enable broadcast storm recovery mode on the interface
and (optionally) set the threshold.
rate
— threshold as percentage of port speed. The
percentage is converted to a PacketsPerSecond value based
on a 512 byte average packet size.
storm-control multicast
[level
rate
]
Enable multicast storm recovery mode on the interface
and (optionally) set the threshold.
rate — threshold as percentage of port speed. The
percentage is converted to a PacketsPerSecond value based
on a 512 byte average packet size.
storm-control unicast
[level
rate
]
Enable unknown unicast storm recovery mode on the
interface and (optionally) set the threshold.
rate
— threshold as percentage of port speed. The
percentage is converted to a PacketsPerSecond value based
on a 512 byte average packet size.