Dell PowerConnect 8024, User Configuration Manual

Page: 1019 / 1294

Configuring OSPF and OSPFv3
1019
To configure Switch B:
1
Create the VLANs.
console(config)# vlan 2,15
2
Enable IPv4 and IPv6 routing on the switch.
console(config)# ip routing
console(config)#
ipv6 unicast-routing
3
Set the OSPF router ID.
console(config)#
router ospf
console(config-router)# router-id 2.2.2.2
console(config-router)# exit
4
Set the OSPFv3 router ID.
console(config)# ipv6 router ospf
console(config-rtr)#
router-id 2.2.2.2
console(config-rtr)# exit
5
Configure the IPv4 address and OSPF area for VLAN 15.
console(config)#i nterface vlan 15
console(config-if-vlan15)# ip address 10.10.10.1 255.255.255.0
console(config-if-vlan15)#
ip ospf area 0.0.0.0
console(config-if-vlan15)# exit
6
Configure the IPv6 address and OSPFv3 information for VLAN 2.
console(config)# interface vlan 2
console(config-if-vlan2)# ipv6 address 2020:2::2/64
console(config-if-vlan2)#
ipv6 ospf
console(config-if-vlan2)# ipv6 ospf network point-to-point
console(config-if-vlan2)# exit
7
Configure the tunnel.
console(config)# interface tunnel 0
console(config-if-tunnel0)#
ipv6 address 2001::2/64
console(config-if-tunnel0)# tunnel mode ipv6ip
console(config-if-tunnel0)# tunnel source 10.10.10.1
console(config-if-tunnel0)#
tunnel destination 20.20.20.1
console(config-if-tunnel0)# ipv6 ospf
console(config-if-tunnel0)# ipv6 ospf network point-to-point
console(config-if-tunnel0)#
exit
8 Configure the loopback interface. The switch uses the loopback IP address
as the OSPF and OSPFv3 router ID.
console(config)#
interface loopback 0
console(config-if-loopback0)# ip address 2.2.2.2 255.255.255.0