5. Disassembly and Assembly Procedures
Use a Philips-head screwdriver to tighten 4pcs
screws for locking rear cover with the assembled
unit. Stick 2pcs labels on the specific positions as
the picture below shown. Insert 1pcs DP cap.
(No.1~4 screw size=M4x10; Torque=12 0.5kgfxcm)
±
Move the assembled rear cover close to the
panel unit, then connect the key cable and USB
FFC cable to the connectors of interface board.
Put down the rear cover and push the rear cover
on the positions marked as the picture below
shown for mechanisms engagement.
S16
Take 1pcs USB board and a connect cable. Connect
the cable to the USB board, then paste 1pcs
conductive foam on the back of the board. Locate
the USB board into the hook of the middle bezel.
Use a Philips-head screwdriver to tighten one screw
for locking the USB unit with middle bezel.
(No.1 screw size=M3x6, Torque=4
±
0.5
kgfxcm)
S14
S17
2
3
4
1
Take 1pcs assembled stand base, then fit the two
tabs on the upper part of the stand into the grooves
on the back of the monitor, and then press the stand
so that the monitor mounting area snaps onto the
stand.
S18
1
Take 1pcs joystick key, 1pcs joystick board and 1pcs
rear cover, then assemble the joystick key with board.
Locate the joystick board to the correct position of the
rear cover, then use a Philips-head screwdriver to
tighten 2pcs screws for locking the joystick board with
rear cover, then fix the key cable with 2pcs tapes.
(No.1~2 screw size=M2x3.3,Torque=1
±
0.2kgfxcm)
1
2
S15
