5. Disassembly and Assembly Procedures
Take 1pcs panel lamp cable to connect the panel with
the circuit board, then tear off the tape on the back
the cable and fix the cable as the picture shown.
Take 1pcs LED board and 1pcs middle bezel, then
put the middle bezel into a fixture jip to fix the middle
bezel. Tear off the release paper on the back of the
board, and then paste the LED board on the correct
position of the middle bezel, then paste 1pcs mylar
tape to cover the LED board, then fix the cable with
2pcs tapes on the middle bezel by tearing off papers.
Connect the LED cable to the connector of the
interface board, then paste 2pcs aluminum foil to fix
the bracket, then paste 1pcs aluminum foil to cover
the LVDS connector of the panel.
S13
Assemble the middle bezel with the front bezel and
panel module, then adjust the middle bezel for two
parts firmly attachment.
S11
Take a front bezel, then lift up the panel unit and
assemble the front bezel with the panel.
Use a Philips-head screwdriver to tighten 13pcs
screws for locking the middle bezel with the panel.
Use a Philips-head screwdriver to tighten 2pcs
screws for locking the middle bezel with the panel.
(No.1~13 screw size=M3x4, Torque=5
±0.5
kgfxcm;
No.14~15 screw size=M1.6x1.7, Torque=1
±0.2
kgfxcm)
S12
2
10
12
1
11
3
8
13
9
7
4
5
6
14
15
S9
1
2
Use a
2pcs
screws for locking the bracket with panel module.
Philips-head screwdriver to tighten
(No.1~2 screw size=M3x4, Torque=5
±0.5
kgfxcm)
S7
S8
S10
