System Setup Program
A-1
Appendix A
System Setup Program
T
his appendix describes the System Setup program, which is used to change
the system configuration information stored in NVRAM on the system board.
To enter the System Setup program, follow these steps:
1. Turn on (or reboot) the system.
2. Press <Ctrl><Alt><Enter> immediately after you see the following
message:
Press
<Ctrl><Alt><Enter>
for Setup
If you wait too long and the operating system begins to load into memory, let
the system complete the load operation; then shut down the system and try
again. You can also enter the System Setup program by responding to certain
error messages.
NOTE: To ensure an orderly system shutdown, consult the documentation that
accompanied the operating system.
