2.
Rotate the power supply back into position until the securing tab snaps into the release latch.
3.
Stand the computer upright.
4.
Replace the computer cover and
restart the computer
.
The computer detects that the new memory does not match the existing configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
5.
Enter system setup, and check the value for
System Memory
. The computer should have already changed the value of
System Memory
to reflect the newly
installed memory. If the new total is correct, skip to
step 7
.
6.
If the memory total is incorrect, repeat
step 1
and
step 3
of "
Removing a Memory Module
." Check the installed modules to ensure that they are seated properly
in their sockets. Then repeat
step 2
through
step 5
of this procedure.
7.
When the
System Memory
total is correct, exit system setup.
8.
Run the Dell Diagnostics to verify that the memory modules are operating properly.
Back to Contents Page
Summary of Contents for OptiPlex GX400
