Replacing the Display Panel
1.
Reconnect the top display-cable connector to the top flex-cable connector.
2.
Reconnect the bottom flex-cable connector to the inverter connector.
3.
Replace the display panel inside the display back cover.
4.
Replace the eight M2 x 5-mm screws (four on each side) in sequential order around the display panel.
5.
Replace the display bezel.
Display Latch
Removing the Display Latch
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the display panel (see
Display Panel
).
5.
Remove the M2 x 4-mm screw that secures the display support bracket to the top cover.
6.
Lift the display support bracket out of the top cover, and then remove the display latch.
Replacing the Display Latch
1.
Align the latch with the posts on the display back and set into place.
NOTE:
The eight screw locations are numbered. Replace the screws in sequential order.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
Before Working Inside Your Computer
) before you
begin working inside the computer.
NOTICE:
A strip of copper foil may be present beneath the support bracket on some systems; ensure that you
do not
tear this foil while removing the
bracket.
1 M2 x 4-mm screw 2 display latch 3 display support bracket
