Steps
1. Align the notch on the solid-state drive with the tab on the M.2 slot.
NOTE:
When replacing the system board, the thermal pad sticker underneath the solid-state drive must be transferred
to the replacement system board.
2. Slide the solid-state drive into the M.2 slot.
3. Replace the single (M2x2.5) screw to secure the solid-state drive to the system board.
4. Using the alignment post, place the solid-state drive shielding cover over the solid-state drive.
Next steps
1. Install the
.
After working inside your computer
.
WWAN card
Removing the WWAN card
Prerequisites
Before working inside your computer
.
2. Remove the
3. Remove the
.
About this task
The following images indicate the location of the WWAN card and provide a visual representation of the removal procedure.
24
Removing and installing components
Summary of Contents for Latitude 9330
