34
Troubleshooting
Beep Codes
Your computer might emit a series of beeps during start-up if the monitor
cannot display errors or problems. This series of beeps, called a beep code,
identifies a problem. One possible beep code consists of repetitive three short
beeps. This beep code tells you that the computer encountered a possible
motherboard failure.
If your computer beeps during start-up:
1
Write down the beep code.
2
Run the Dell™ Diagnostics to identify a more serious cause (see "Dell
Diagnostics" on page 42).
Code
(repetitive
short beeps)
Description
Suggested Remedy
1
BIOS checksum
failure. Possible
motherboard failure.
Contact Dell.
2
No memory modules
are detected
1
If you have two or more memory modules
installed, remove the modules, reinstall one
module (see
your
Service Manual
at
support.dell.com
), and then restart the
computer. If the computer starts normally,
reinstall an additional module. Continue until
you have identified a faulty module or
reinstalled all modules without error.
2
If available, install good memory of the same
type into your computer see
your
Service
Manual
at
support.dell.com
).
3
If the problem persists, contact Dell.
3
Possible system
board failure
Contact Dell.
Summary of Contents for Latitiude E6500
