1.
Follow the instructions in "
Before Working Inside Your Computer
."
2.
Remove the
display assembly
.
3.
Remove the
display bezel
.
4.
Remove the four M2 x 3-mm screws from each side of the display panel.
5.
Lift the display panel out of the top cover.
6.
Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
7.
Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
Installing the Display Panel
1.
Connect the top flex-cable connector to the display panel connector.
2.
Connect the bottom flex-cable connector to the inverter connector.
3.
Lay the display panel into the top cover.
4.
Route the display-feed flex cable so that it rests in the notch located in the bottom edge of the top cover.
5.
Replace the eight M2 x 3-mm screws that secure the display panel to the top cover.
6.
Replace the
display bezel
.
Back to Contents Page
CAUTION:
Before performing the following procedures, read the safety instructions in the
Product Information Guide
.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
1
inverter connector
2
pull-tab on bottom flex-
cable connector
3
top flex-cable connector
4
display connector
Summary of Contents for Inspiron i1200
Page 8: ...Back to Contents Page ...
Page 45: ...Back to Contents Page ...
