Dell Inspiron 8600, Owner'S Manual

Page: 125 / 174

Adding and Replacing Parts 125
Replacing the Hard Drive
NOTE: You need the
Operating System
CD to install the Microsoft
®
Windows
®
operating
system. You also need the
Drivers and Utilities
CD for your computer to install the drivers and
utilities on the new hard drive.
CAUTION: If you remove the hard drive from the computer when the drive is hot,
do not touch
the metal housing of the hard drive.
CAUTION: Before working inside your computer, read the safety instructions at
the front of this document (see page 11).
NOTICE: To prevent data loss, turn off your computer (see page 42) before removing the hard
drive. Do not remove the hard drive while the computer is on, in standby mode, or in hibernate
mode.
NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources
other than Dell.
To replace the hard drive in the hard drive bay:
1
Ensure that the work surface is flat and clean to prevent scratching the computer
cover.
2
Save and close any open files, exit any open programs, and then shut down the
computer (see
page 42
).
3
If the computer is connected to a docking device (docked), undock it. See the
documentation that came with your docking device for instructions.
4
Disconnect the computer from the electrical outlet.
5
Wait 10 to 20 seconds, and then disconnect any attached devices.
6
Remove any installed PC Cards, batteries, and module bay devices.
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.
Ground yourself by touching a metal connector on the back of the computer. Continue to ground
yourself periodically during this procedure.