NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
Steps
1. Using the alignment posts and rubber grommets, place the left speaker on the slots of the palm-rest and antenna assembly.
2. Route the speaker cable through the routing guides on the palm-rest and antenna assembly.
3. Using the alignment posts and rubber grommets, place the right speaker on the slots of the palm-rest and antenna assembly.
4. Connect the speaker cable to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Heat sink
Removing the heatsink
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
3. Remove the
.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
Removing and installing components
31
Summary of Contents for Inspiron 7791 2n1
Page 1: ...Inspiron 7791 2n1 Service Manual Regulatory Model P42E Regulatory Type P42E001 ...
Page 12: ...12 Removing and installing components ...
Page 34: ...34 Removing and installing components ...
Page 35: ...Removing and installing components 35 ...
