2. Lift the latch, and disconnect the fingerprint-reader board cable, if installed, from the connector on the palm-rest assembly.
NOTE:
Remove the fingerprint-reader board cable and keep it aside as it is already disconnected from the other end.
3. Unplug the power-button cable from the fingerprint-reader board on the palm-rest assembly.
4. Remove the single screw (M1.6x2.5), and lift the bracket.
5. Remove the single screw (M1.6x2.5) that secures the power button with optional fingerprint reader to the palm-rest assembly.
6. Lift the power button with optional fingerprint reader, along with the fingerprint reader cable, off the palm-rest and keyboard
assembly.
Installing the power button with optional fingerprint
reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the installation
procedure.
Removing and installing components
45
