CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3. Connect the display cable to the connector on the system board and close the latch.
4. Adhere the tape that secures the display-cable connector latch to the system board.
5. Adhere the display-cable connector to the palm-rest and keyboard assembly.
6. Connect the display cable to the display board and close the latch.
7. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
8. Replace the three screws (M2.5x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
9. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
10. Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
.
After working inside your computer
.
Display board
Removing the display board
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
The following image(s) indicate the location of the display board and provides a visual representation of the removal procedure.
Steps
1. Lift the latch and disconnect the display cable from the display board.
2. Remove the two screws (M2x2) that secure the display board to the palm-rest and keyboard assembly.
50
Removing and installing components
