Figure 44. Removing a processor and heat sink module
Next steps
If you are removing a faulty heat sink,
, if not,
.
Removing the processor from the processor heat sink module
Prerequisites
WARNING:
Remove the processor from processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3. If installed,
4.
Remove the processor and heat sind module (PHM) or the liquid cooling module
CAUTION:
You may find the CMOS battery loss or CMOS checksum error displayed during the first instance of
powering on the system after replacing the processor or system board. To fix this, simply go to setup option to
configure the system settings.
Steps
1. Place the PHM with the processor side facing up.
2. Using your thumb, lift up the Thermal Interface Material (TIM) break lever to release the processor from the TIM and carrier.
3. Holding the processor by its edges, lift the processor away from the carrier.
NOTE:
Ensure to hold the carrier to the heat sink as you lift the TIM break lever.
62
Installing and removing system components
