Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 35. Removing the rear mounting front PERC module
Next steps
1.
Replace the rear mounting front PERC module
.
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the drive backplane cover
4. If installed,
5.
.
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
Installing and removing system components
47
