Dell EMC VxFlex Ready Node, Installation Manual

Page: 36 / 92

Connect and route cords and cables
Procedure
1. Connect the power cords and I/O cables as described in documentation for your system.
2. If the system uses a cable management arm (CMA), install it as described in the document shipped with the
CMA.
3. If the system does not use a CMA, use the two velcro straps to route and secure cords and cables at the rear of
the system:
a. Locate the CMA bracket slots on the rear end of both the rails.
b. Bundle the cables gently, pulling them clear of the system connectors to the left and right sides.
Note: Ensure that there is enough space for the cables to move when you slide the system out of the
rack.
c. Thread the straps through the CMA bracket slots on each side of the system to hold the cable bundles.
Figure 17 CMA bracket slots
R640 Equipment Installation
36 Dell EMC VxFlex Ready Node Server Installation Guide