Figure 109. Installing the front mounting front PERC module
Next steps
1.
.
2. Follow the procedure listed in
After working inside the system
Rear drive module
This is a service technician replaceable part only.
Removing the rear drive module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4.
.
5. Disconnect the signal and power cables connected to the rear drive module.
NOTE:
The 2 x 2.5-inch rear drive module can be installed only with 12 x 3.5-inch backplane configuration system.
Steps
1. Loosen the captive screw using Phillips #2 screw driver.
2. Slide the rear drive towards the PIB to unlock it from the system.
Installing and removing system components
111
