Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2
Release the two blue side plastic snaps holding the LOM riser card.
3
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP are clear of the slot in the back
panel.
Figure 66. Removing LOM riser card
Next step
Install the LOM riser card.
Installing the LOM riser card
Prerequisite
Follow the safety guidelines listed in
Steps
1
Orient the LOM riser card to fit through the Ethernet connectors or the SFP slot on the system.
2
Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic snap holds the LOM
riser card in place.
3
Using Phillips #2 screwdriver, tighten the screws to secure the LOM riser card to the system board.
Next steps
1
If removed, install the LP or FHX1.
2
Follow the procedure listed in
After working inside your system
.
Hard drive backplane
Depending on your system configuration, the hard drive backplanes supported in PowerEdge R440 are listed here:
Installing and removing system components
79