Figure 21. Removing the intrusion switch module
Next steps
Replace the intrusion switch module
.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
Steps
1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
32
Installing and removing system components
