Dell Edge Gateway 5000 Series, Installation And Operation Manual, Page: 10 / 64

Setting up your Dell Edge
Gateway
WARNING: Before you begin any of the procedures in this section,
read the safety information that shipped with your system. For
additional best practices information, go to www.dell.com/
regulatory_compliance.
WARNING: When installing the Gateway, the responsible party or
integrator shall use the AC Adapter provided with the Dell Edge
Gateway, or connect to a 24Vac or 24Vdc power source already
present as part of the clients installation.
WARNING: The Dell AC Adapter (full-wave rectified and have no built-
in isolation transformer) is acceptable for use up to ambient
temperature of 40°C and is a limited power source, SELV/Limited
Energy Circuit, Class 2 power source. If ambient temperature of the
installation exceeds 40 °C then use the 24Vac or 24Vdc power
available as part of the installation.
WARNING: Always make sure that the available power source matches
the required input power of the Dell Edge Gateway, check the input
power markings next to power connector(s) before making
connections. The 24 V power source must be compliant with local
Electrical Codes and Regulations.
WARNING: To ensure the protection provided by Dell Edge Gateway is
not impaired, do not use or install the system in any manner other
than that which is specified in this manual.
WARNING: When installing the Gateway use acable appropriate for the
load currents: 3-core cable rated 5 A at 90 °C (194 °F) minimum, which
conform to either IEC 60227 or IEC 60245. The system accepts cables
from 0.8 to 2.5 mm (18 to 14 AWG).
WARNING: The symbol indicates hot surface or adjacent hot
surface that can obtain temperature during normal use that can cause
a burn. Allow equipment to cool off or use protective gloves when
handling to reduce risk of a burn.
WARNING: If a battery is included as part of System/Network, battery
must be must be installed with appropriate enclosure in accordance
with local Fire and Electrical Codes and Laws.
10