Hardware Overview
9
Base Module
The MXL 10/40GbE Switch provides two native 40-Gigabit Ethernet fixed ports
on the base module for uplink connections. You can use these ports with 4x10G
breakout cables to operate as 10GbE uplink ports.
In addition, you can configure the native 40GbE ports as stacking ports. You
can connect up to six MXL 10/40GbE Switches (in the same or different
chassis) in a single stack. For more information, refer to Assembling a Switch
Stack.
FlexIO
TM
Plug-in Modules
The MXL 10/40GbE Switch (Figure 1-2) provides 10/40GbE external
connectivity by using the following FlexIO plug-in modules in the two
expansion slots:
• 4-Port 10-Gigabit Ethernet module using SFP+ optics (SR or LR) or
direct-attach cables (1m, 3m, or 5m DAC)
• 4-Port 10GBASE-T module using RJ-45 connector (copper) cables
NOTE:
The 10Mb speed is not supported on the 4-Port 10GBASE-T module.
Only 100Mb, 1GbE, and 10GbE speeds are supported.
• 2-Port 40-Gigabit Ethernet QSFP+ module which you can use for 40GbE
connections or 10GbE SFP+ connections using 4x10G breakout cables.
By default, the 40GbE ports on a 2-Port 40GbE QSFP+ module come up
in 4x10GbE (quad) mode as eight 10GbE ports. To change a port from
4x10GbE to 40GbE mode of operation, enter the
no stack-unit port
portmode quad
command.
Dell(conf)# no stack-unit
unit-number
port
port-number
portmode quad
stack-unit
unit-number
: Enter the number of the stack unit to
be reset. The range is from 0 to 5. To display the stack-unit number,
enter the
show system brief
command.
port
port-number
: Enter the port number of the 40GbE QSFP+
port to be split. Valid values for slot 0: 41 or 45; for slot 1: 49 or 53
(refer to Port Numbering).
portmode quad
: Identifies the port as a split 10GbE SFP+ port.
Summary of Contents for DF10MXL
Page 6: ...6 Contents ...
Page 35: ......
Page 36: ...www dell com support dell com Printed in the U S A ...
