Installing and Maintaining the C300 System
13
3
Preparing the Site
Site Selection Criteria
Before beginning the installation process, make sure that the area where you intend to install your C7008/
C300 meets the following safety requirements:
•
It is in a restricted access area.
•
It is in a dry, clean, well-ventilated, temperature-controlled room, that is away from heat sources such as
hot air vents or direct sunlight.
•
It is away from sources of severe electromagnetic noise.
•
Power supply is adequate for power requirements.
•
Connect the C-Series System to the appropriate branch circuit protection as defined by local
electrical codes.
WARNING:
The C7008/C300 does not have a main disconnect device installed. It is the responsibility of the
installer to provide a suitable disconnecting device in the building installation and ensure that it is located/
installed near the equipment and is easily accessible.
•
It is positioned in a rack with adequate space in the front, rear, and sides of the unit for proper
ventilation, access to cables, and maintenance access.
•
Allow
at least
six inches (16 cm) of clearance around the side intake and exhaust vents.
•
Allow
at least
12 inches (30.5 cm) between two C7008s/C300s or an C7008/C300 and another
side airflow chassis.
•
Allow
at least
18 inches in the front and 20 inches in the rear of the rack.
NOTE:
The C-Series does not have an air filter, so take special care in making sure that the installation site
and the chassis itself are cleaned regularly.
Summary of Contents for C300
