Dell 1135N, Service Manual

Page: 98 / 169

Alignment and Troubleshooting
4-25
Service Manual
Message Meaning Suggested solutions
DHCP problem:
Auto IP Run
The IP address assignment is failed.
This happens, when Auto IP for DHCP
is not set in SyncThru Web Service.
Change the IP address assignment
method to BOOTP or Static. If you
do not change this option, the DHCP
server continually asks to assign the
IP Address.
Document Jam.
Remove Jam
The loaded original has jammed in the
ADF.
Open the ADF cover and clear the jam.
Door Open.
Close it
The front cover is not securely
latched.
1. Close the cover until it locks into
place.
2. Enter the EDC mode and check the
cover status.
Error #02-000~2
Turn off then on
A fuser error has occurred. 1. Turn the printer off and back on to
continue.
2. Reconnect the cable between the
fuser and SMPS board.
3. Remove the fuser and re-install it.
4. Check the thermostat. If it is
defective, replace it.
5. If error persists, replace the fuser.
6. If error persists, replace the SMPS/
HVPS board.
Install Toner
Install it
The toner cartridge is installed
improperly, or not installed.
Reinstall the toner cartridge two or
three times to confirm it is seated
properly. If the problem persists, the
toner cartridge is not being detected.
Memory Full
Remove Job
The memory is full. Press the left/right arrow to highlight
Cancel or Start, then press OK. If you
select Cancel , the machine stops the
fax job. If you select Start, the machine
only sends scanned documents of the
fax job.
Network Problem:
IP Conflict
The IP address is used elsewhere. Check the IP address or obtain a new
IP address.
Not Compatible
Toner cartridge
The indicated toner cartridge is not
suitable for your machine.
Install the corresponding toner
cartridge with a Samsung-genuine
cartridge.
Output bin Full
Remove paper
The output tray is full.
Or the sensor is not facing down.
Remove papers from the output tray,
the machine resumes printing. Or
make sure the sensor is facing down.