Installing and removing sled components
This section provides information about installing and removing the sled components. For information about installing and removing the
enclosure components, see the enclosure Owner's Manual at
Dell.com/poweredgemanuals
.
Topics:
•
•
•
•
•
•
•
•
Internal Dual SD Module (IDSDM) card
•
•
LAN on Motherboard (LOM) riser card
•
•
Processor blank and DIMM blank
•
•
Solid State Drive (SSD) backplane
•
•
•
Safety instructions
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE:
Dell recommends that you always use an antistatic mat and antistatic wrist strap while working on components inside the
system.
CAUTION:
Operating the system without the system cover can result in component damage
NOTE:
To ensure proper operation and cooling, all bays in the system must be populated always with either a system component
or with a blank.
Before working inside your system
Prerequisites
Follow the safety guidelines listed in safety instructions section.
6
Installing and removing sled components
47
