Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the single screw (M2x3) to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the system board.
Next steps
1. Install the
.
2. Install the
.
3. Install the
4. Install the
.
After working inside your computer
.
Heat sink
Removing the heat sink
Prerequisites
before working inside your computer
.
CAUTION:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
2. Enter
.
3. Remove the
4. Remove the
.
5. Remove the
.
6. Remove the
.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
Removing and installing components
43
Summary of Contents for Latitude 5420
