Quick Installation Guide
Installation
deliberant
Page 9
Assembling and mounting the APC 5M-18 V2
The APC 5M-18 V2 units are supplied with mounting hardware for pole with diameters in the range
40mm to 50mm installations. After the unit is attached, its position is fixed with the single bolt. Follow
the steps for APC 5M-18 V2 assembling:
Step 1.
Make sure that the APC unit is powered-off.
Step 2.
Ground the APC 5M-18 V2 unit. The unit must be properly grounded to protect against
lightning. The grounding wire must be attached to the grounding stud on the unit (refer
at the
Figure 2
– APC 5M-18 V2 Overview
).
If the unit is attached to a metal pipe which is earth-grounded, no further grounding is
required.
Step 3.
Attach mounting hardware (item C in the
Figure 1
– APC 5M-18 V2 Package Contents
)
to the unit and tighten with the nut and bolt (items I and J in
the Figure 1
– APC 5M-18
V2 Package Contents
).
For wall mounting, first attach the mounting bracket to the wall and then connect the unit
together and tighten the nut and bolt.
It is recommended not to tighten the unit to its mounting hardware until the alignment
process of the antenna is complete.
Step 4.
For pole mounting attach APC 5M-18 V2 on pole with U bolt (items H and J in the
Figure 1
– APC 5M-18 V2 Package Contents
) as shown in picture below:
Step 5.
Connect Ethernet cable into the APC 5M-18 V2 then insert a rubber gasket (item F in
the
Figure 1
– APC 5M-18 V2 Package Contents
) into CAT5 Ethernet connector gland
and tighten with gland cap (item E in the
Figure 1
– APC 5M-18 V2 Package Contents
)
as displayed below:
