Quick Installation Guide
Installation
deliberant
Page 10
It is recommended to use shielded STP Ethernet cable to reduce exposure of the
electromagnetic noise.
Step 6.
Connect power adapter into PoE injector together with UTP cables as displayed in
picture below:
Step 7.
Power-up the unit. The green Power LED must be on (refer at the respective section
LEDs
). Depending on link quality, up to four yellow LEDs will switch on indicating that
link between two units was established successfully.
Step 8.
After the link was established, align the antenna for the maximum performance. Run
the
Antenna Alignment
tool in the Web management interface and move the unit in
the horizontal and vertical planes until the maximum RSSI visible on the Antenna
Alignment graph is achieved. After the maximal RSSI is reached, tighten down the unit
in the optimum position.
Avoid standing directly in front of an operating antenna while aligning.
