Shelleyglas
®
/Shelleysteel™ Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
2
Shelleyglas
®
/Shelleysteel™ Service and Installation Manual
3
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
If your unit is
heated
, the serial tag is located above the
louvered panel near the on/off switch.
Refrigerated
units have the serial tag located in the
compressor area near the on/off switch.
Understorage
units often have the serial tag located on the
left inside the storage area.
All purpose counters, utility equipment or delivery carts
do
not require serial numbers but a model tag is placed at the
top of the pylon on the back of the unit.
Always have the serial number of your unit available when
calling for parts or service.
This manual covers standard units only. If you have a
custom unit, consult the customer service department at the
number listed below.
©2003 The Delfield Company. All rights reserved. Reproduction without
written permission is prohibited.
“Delfield” is a registered trademarks of The Delfield Company.
CONTENTS
SERIAL NUMBER INFORMATION
RECEIVING AND INSPECTING THE EQUIPMENT
RECEIVING & INSPECTING EQUIPMENT .................................2
SPECIFICATIONS........................................................................3
INSTALLATION ..........................................................................4
OPERATION.............................................................................4-5
MAINTENANCE ..........................................................................6
CLEANING LIQUITEC .................................................................7
FOOD WELL ASSEMBLY............................................................7
WIRING DIAGRAM .................................................................8-9
STANDARD LABOR GUIDELINES............................................10
REPLACEMENT PARTS LIST...................................................11
STANDARD WARRANTY..........................................................11
PARTS DEPOTS ........................................................BACK PAGE
Even though most equipment is shipped crated, care should
be taken during unloading so the equipment is not damaged
while being moved into the building.
1. Visually inspect the exterior of the package and skid or
container. Any damage should be noted and reported
to the delivering carrier immediately.
2. If damaged, open and inspect the contents with the
carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally
as well as in written form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10
days from receipt of the equipment.
5. Check the lower portion of the unit to be sure legs or
casters are not bent.
6. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines
are secure and base is still intact.
7. Freight carriers can supply the necessary damage forms
upon request.
8. Retain all crating material until an inspection has been
made or waived.
The units with LiquiTec technology cold pans con-
tain a non-toxic eutectic fluid within a sealed inner
liner. This fluid may leak if the tank is punctured
so care must be taken when uncrating and setting
in place. The eutectic fluid is non-toxic and may be
flushed down a disposal drain. If the LiquiTec unit
cold pans leak, immediately call the Delfield service
department directly at 1-800-733-8821 not your
local service agent.
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required. If the unit is on legs remove the top of the crate
as well and lift the unit off the skid. If the unit is on casters
it can be "rolled" off the skid.
