Delfield CV10E, Installation, Operation And Maintenance Manual

Page: 35 / 40

Section 6 Trouble shooting
Part Number: 9291000 06/22 35
Parem. Label Description Min Max Default U.M. Type
C1 Chilling duration by time and max chilling by temperature 0 400 90 min User
C2 Set chilling end (higher between the two probes) C2A C2B 3 °C User
C2A Min. product temp for chilling by temperature -50 C2B 1 °C
C2B Max. product temp for chilling by temperature C2A 90 10 °C
C3 Set positive storage (referred to the cabinet probe) -50 90 2 °C User
C4 During the freezing by time and max. duration provided
for the freezing by temp. (with C4=0, then the freezing key
and function equal to 0°F, or -18°C, will be disabled. Only for
positive blast chilling)
0 400 240 min User
C5 Set freezing end (referred to the needle probe with higher T°) C5A C5B -25 °C
C5A Min. product temp for freezing by temp. -50 C5B -25 °C
C5B Max. product temp for freezing by temp C5A 90 -5 °C
C6 Set negative storage (referred to the cabinet probe) -50 90 -25 °C User
C7 Needle test threshold 0 99 5 °C
C8 Start temp for counting the chilling and freezing duration
(above that value, the counting will start)
-50 90 65 °C
C9 Acoustic signal activation time at the end of the chilling 0 99 60 sec User
CA Needle 1 probe reading (read only) -- -- -- °C User
CA1 Needle 2 probe reading (read only) -- -- -- °C User
CB1 Set cabinet in SOFT+SOFT chilling (cabinet probe) -50 90 -3 °C
CB2 Set cabinet in SOFT chilling (cabinet probe) and second
phase of HARD chilling
-50 90 -5 °C
CC Set cabinet in freezing (cabinet probe) -50 90 -40 °C
CD Set HARD end (HARD to SOFT, needle probe temperature) -50 90 20 °C
CE Duration of differential test X verification of probe insertion
(needle test time)
0 99 0 sec
CF Set cabinet during the first HARD chilling phase (cabinet
probe)
-50 90 -20 °C
CS Set second cabinet for the negative SOFT cycle phase -50 90 -30 °C
Ice Cream
T0 Ice cream hardening duration 1 400 10 min User
TH Positive cycle hard phase percentage 1 100 35 %
TS Negative cycle soft phase percentage 1 100 30 %
Compressor Protection
CC0 Compressor start delay upon turning on the tool 0 9 2 min
CC2 Min compressor pause 0 99 3 min
CC4 2nd compressor activation delay (with CC4=0 K3 output as
liquid solenoid valve, otherwise K3 output as 2nd compressor,
it is not possible to activate the defrost with HOT GAS)
0 9 0 sec
CC5 Compressor cycle time (On + Off) in case of cabinet probe
error
0 99 10 min
CC6 Compressor On time (in positive storage) in case of cabinet
probe error
0 99 3 min