Delfield 4427N, Installation & Operation Manual

Page: 12 / 24

12
Delfield
Cutting Board Bracket Mounting
1. Gather brackets, cutting board and screwdriver.
2. Open the door to install the center bracket.
3. Remove four screws from the nosing.
4. Place the bracket and secure with the four removed
screws.
5. Remove two screws from one end.
6. Place the bracket and secure with the two removed
screws.
7. Repeat at the other end.
8. Insert the cutting board into the brackets, back first.
Lay it down with the holes over the alignment pins.
Shelf Installation Instructions
1. Notice the shelves have four alignment pins on the
underside and a backstop on the top back.
2. Insert the shelves into the cabinet.
• The backstop should be at the top back.
• The alignment pins should be in front and back of
the shelf supports.
Changing Pan Height
If additional pan temperature cooling ability is desired,
especially in higher ambient temperature conditions and/
or if pan covers are open or off for extended time periods
improved cooling of pans can usually be achieved by utilizing
the lower position of the dual level pan guides.
When utilizing the lower position on a model with drawers,
only 4" deep pans can be used in the top. When utilizing the
lower position on a door model, 4" or 6" deep pans may be
used.
1. Remove all pans, pan dividers, front and rear support
bars.
2. Remove the upper side support brackets by pulling them
up and off as shown below.
3. Reinstall all components removed in step one.
If the lower pan position is desired for model 4427N-12M,
model specific brackets must be ordered. They will hold pans
at the lower position and replace all other brackets.
Installation, continued
Use side support alone
to lower pans 1”
Remove upper side
support bracket