Part Number: 9291456 11/17
17
DANGER
It is the responsibility of the equipment owner to
perform a Personal Protective Equipment Hazard
Assessment to ensure adequate protection during
maintenance procedures.
DANGER
Failure to disconnect the power at the main power
supply disconnect could result in serious injury or death.
The power switch DOES NOT disconnect all incoming
power.
DANGER
Disconnect electric power at the main power disconnect
for all equipment being serviced. Observe correct
polarity of incoming line voltage. Incorrect polarity can
lead to erratic operation.
n
Warning
Never use sharp objects or tools to remove ice or frost.
Do not use mechanical devices or other means to
accelerate the defrosting process.
Section 4
Maintenance
Maintenance
Daily
Weekly
Monthly
After Prolonged
Shutdown
At Start-Up
Interior & Exterior
X
X
X
Lid and/or Gasket
X
X
X
X
N225 & N227
Condenser Coil
X
X
X
Cleaning and Sanitizing Procedures
n
Warning
When using cleaning fluids or chemicals, rubber gloves
and eye protection (and/or face shield) must be worn.
,
Caution
Maintenance and servicing work other than cleaning as
described in this manual must be done by an authorized
service personnel.
Note
When cleaning the unit, care should be taken to avoid
the power cord. Keep water and/or cleaning solutions
away from these parts.
Note
Never use a high-pressure water jet for cleaning or
hose down or flood the units with water. Do not use
power cleaning equipment, steel wool, scrapers or wire
brushes on stainless steel or painted surfaces.
Note
Never use an acid based cleaning solution! Many food
products have an acidic content, which can deteriorate
the finish. Be sure to clean the stainless steel surfaces of
ALL food products.
INTERIOR & EXTERIOR
You are responsible for maintaining the equipment
in accordance with the instructions in this manual.
Maintenance procedures are not covered by the warranty.
Clean the lid and the unit daily or more often to maintain
cleanliness and efficient operation.
Gaskets require daily cleaning to prevent mold and
mildew build up and also to retain the elasticity of the
gasket. Gasket cleaning can be done with the use of warm
soapy water (not citrus based cleaner). Avoid full strength
cleaning products on gaskets as this can cause them to
become brittle and crack. Never use sharp tools or knives to
scrape or clean the gasket.