Delem DAC-360, Installation Manual

Page: 63 / 82

Delem
V0208, 2.37
This is the time the output B_UP must remain active after UDP has been reached.
Parameter 99
Opening force
Range : 0 - 100
Unit : %
Default : 50
Function
The force for steering the blade up. This value is programmed as a percentage of the
maximum force (as programmed in the reference table).
Parameter 100
Opening delay
Range : 0 - 9999
Unit : msec
Default : 0
Function
When the ‘end of stroke’ is reached, the control will start opening control to move the blade
up. This parameter can be used to program a delay before opening control is started. An
opening delay is useful to overcome the response time of the clamping system and/or the
pressure control system (in case of force control).
In the timing diagrams, this delay is called T3. When ½T3 has elapsed, the signal B_UP is
activated. When T3 has elapsed completely, the pressure output is activated (in case of force
control).
Parameter 101
Angle/Gap force
Range : 0 - 9999
Unit : kN
Default : 0
Function
Force value in case of angle or gap control.
If the force is controlled and angle control or gap control is implemented, the main force is
controlled at this value whenever angle or gap are positioned.
Parameter 102
Clamping force
Range : 0 - 100
Unit : %
Default : 0
Function