Del ozone AGW Series, Installation & Operation Manual

Page: 6 / 36

2
AGW–4015/4025/4045 Installation & Operations Manual
2B. Electrical
Main Power Supply Circuit:
Refer to Section 1B Specifications, Power
Requirements and local electrical codes for
information on proper electrical connection. Unit
is supplied with flying leads for direct "hard wire"
connection to be wired in accordance with electrical
codes.
2C. Plumbing
Water Inlet Connection: 1.5” FPT
Water Outlet Connection: 2” FPT
SECTION 3
System Configuration /
Installation Diagrams
The following 3 pages include diagrams for:
3A. Tank Charging System - Page 3
3B. Tank Cleaning System - Page 4
3C. Spray System - Page 5
SECTION 4 Operation
4A. Control Panel Overview
4A-1. Indicator Lights
Green Lights 1.
Main Power (Ozone Generator): a.
indicates
that power is being supplied to the Ozone
Generator.
Ozone Power: b.
indicates that power is being
supplied to the high voltage Corona
Discharge circuits and that ozone is being
produced (See Sections 4B and 4C).
Pump On: c.
indicates that the pump is
running.
Red Lights (Ozone Generator) 2.
Vacuum: a.
indicates that vacuum is out of
range. The light will be lit for low vacuum
conditions.
High Coolant Temperature: b.
indicates that
water temperature is over 110 °F. (Refer to
TROUBLESHOOTING Section.)
Water Back Flow Detected: c.
indicates that
water back flow from the injector into the
generator has been detected. (Refer to
TROUBLESHOOTING Section.)
Flow Meter
Ozone Power Switch
Dissolved Ozone
Monitor/Controller
Main Power Switch
Pump On
Inlet Pressure Gauge
Main Power
Ozone Power
Vacuum
High Coolant Temperature
Back Pressure Gauge
Injector Vacuum Gauge
Water Backflow Detected
Figure 2: AGW–4015/4025/4045 Control Panel