Deitz Pharmafill NB1, Operation Manual

Page: 87 / 87

DEITZ COMPANY INC Technical Information Document No. TN0122-4
April 26, 2021 Model NB1 Neck Bander
TN0122-4 How to use Model NB1 with Print Registration
Clear Film, Registered Print Film And Random Print Film
Machines with PLC program version NB1_PLC_2020-03-09 (or later) and the
optional print registration sensor can be used with both clear film and printed
film. The default factory setting is for use with clear or random print film (SPEED 2
= 200). To use registered print film, you will need to change a setting, so that the
fiber optic sensor will control the cut location (SPEED 2 = 9200). Either setting
works with clear film.
To switch from factory default CLEAR or RANDOM PRINT to CLEAR or REGISTERED
PRINT:
1. On the HMI (control panel), go to the TECHNICIAN ONLY menu.
2. The keypad will appear. Enter password 59 and press ENTER .
3. Find the entry for SPEED 2 (factory default is 200)
4. Touch the value for SPEED 2 and the keypad will appear.
5. On the keypad, press CLEAR , enter 9200 , then press ENTER .
6. Press DONE to accept.
7. Turn the machine off (press E-stop) and on (release E-stop) to update the
system.
8. Test with REGISTERED PRINT FILM. With this type of film, the length setting
determines how far the film will advance after the fiber optics detect the clear
gap in the film. This length setting is a constant (approximately 1.25 inches).
The final length of the film is determined by the space between clear gaps. Try
LENGTH = 1.25 inches to start and make small adjustments up or down until
the cut is in the desired place.