Deitz Pharmafill NB1, Operation Manual

Page: 32 / 87

2022-03-08 Pharmafill Model NB1
Deitz Company Inc. NB1 User Manual Page 26
Section 8 – SET UP (cont’d)
2. ADJUST MACHINE HEIGHT
a.
Place container on conveyor, under the lowest point of the knife assembly, which is the Anchor Block.
b. Use the hand crank on the lift stand to raise or lower machine to allow the container to pass under the
knife assembly with approximately
½” clearance under the Anchor Block (to be fine-tuned later).
c. When the correct height is established, measure the distance from the conveyor top surface to the
bottom of the machine cabinet. Save this information for future set ups.
3. START SENSOR HEIGHT - Adjust start sensor height so that passing container cap will interrupt beam.
d.
The Start Sensor is a reflective-type photoelectric sensor. It is infrared, so the light is not visible. The
green LED is
‘ power ’ , the yellow LED is ‘ signal ’ and the round clear area is the light source/receiver.
e. With a container on the conveyor, loosen the black handle on the left and move start sensor down to
a height that will cause the cap or the body of the container to interrupt the sensor.
ANCHOR
BLOCK
CONVEYOR TOP
BOTTOM
OF
MACHINE
CABINET
REFLECTOR
(HIDDEN)
TAMPER BRACKET
START
SENSOR