3. Highlight the parameter category you wish to open, by pressing
Up
or
Down
.
4. Select the highlighted parameter category by pressing
OK
.
•
The parameter groups under the selected category are shown on the display.
5. Highlight the parameter group you wish to open, by pressing
Up
or
Down
.
6. Select the highlighted parameter group by pressing
OK
.
•
The parameter settings are shown on the display.
7. To highlight the parameter, select
Up
or
Down
.
8. To highlight the parameter settings, press
Up
or
Down
.
9. Change the setting by pressing
OK
.
•
If the setting can be toggled, you can use
Toggle
Toggle
.
•
If the setting is text or a value, pressing
OK
displays the
virtual keyboard
to alter the setting.
◦
The parameter settings
minimum
,
maximum
and
default
are also shown.
◦
Use the
Virtual keyboard
to make the required changes.
◦
To confirm the setting, select
Write
.
•
If the setting is a curve:
◦
Highlight
Setup
, by pressing
Up
or
Down
.
◦
Select the option, by pressing
OK
.
◦
The curve (graph) is now displayed.
◦
See
View or configure curve
in this chapter for more information.
7.5.2 View or configure a curve
INFO
In order to view or configure a curve, a curve function must be configured in the input/output configuration. See example
shown below for further information.
Configure the curve settings
Figure 7.3
Example derate curve
To configure the curve settings, perform the following steps:
OPERATOR'S MANUAL 4189341099G UK
Page 44 of 130
