24
www.degardo.de
TREVIA | STORUS | VARIA | ROVIO
Figure D – Changing the bulb for ROVIO III/IV and STORUS V
(Item No.: 207869, 210781, 227673)
Notice:
ROVIO IIII / IV LED (Item no.: 205666, 205780)
Repairs to the electrical system may only be carried out by a qualified electrician. The LED
bulbs are fixed to the product and may not be repaired or replaced by laypersons. If repairs
are required, the product must be returned via the dealer or directly to DEGARDO®. The
address can be found on the back page of these operating instructions. Please include full
contact details, a copy of your proof of purchase and a detailed description of the fault. The
warranty will cease to be valid if any incorrect repairs are carried out.
1. Remove the plug from the socket to disconnect the equipment from the power supply.
2. Loosen the 6 screws (2) on the retainer (1) for the bulb unit.
3. Carefully pull out the retainer (1) with the bulb (5).
4. Loosen the clamp (3) and the 2 reusable cable ties (4).
5. Carefully remove the bulb (5) from the socket.
6. Fit a new bulb (5).
7. Refit the clamp (3) and the 2 reusable cable ties (4).
8. Push the retainer (1) with the new bulb (5) into the opening and screw the retainer (1)
back down with the 6 screws (2).
9. Replace the plug in the socket to reconnect the equipment to the power supply.
Figure E – Changing the bulb for TREVIA I, II, III and IV
(Item No.: 170417, 177076, 177077, 193770)
1. Remove the plug from the socket to disconnect the equipment from the power supply.
2. Unscrew the cover from the service opening (1).
Notice:
The opening is restricted. Take care not to cause any damage. Work carefully and slowly.
3. Loosen the wing nut (3) on the lever (2).
4. Swing the socket (4) downwards.
5. Unscrew the faulty bulb from the socket (4).
6. Screw the new bulb into the socket (4).
7. Move the lever (2) back to the starting position.
8. Tighten the wing nut (3) on the lever (2).
9. Screw the cover (1) back into position.
10. Replace the plug in the socket to reconnect the equipment to the power supply.
Figure F – Changing the bulb for TREVIA V
(Item No.: 227625, 227626)
1. Remove the plug from the socket to disconnect the equipment from the power supply.
2. Loosen the 8 screws (1) on the insert.
3. Take out the insert (2).
4. Unscrew the faulty bulb (4) from the socket (3).
5. Screw the new bulb (4) into the socket (3).
6.
Fit the insert (2) back into the opening and screw the insert (2) into position using the 8 screws (1).
7. Replace the plug in the socket to reconnect the equipment to the power supply.
