•
“A”
1 x Stability chain
•
“B”
1 x Stability hook with anchor sleeve
•
“A”
is factory fitted at the rear of the stove in
the centre. (See overleaf for instructions if the
removable splashback is to be fitted)
•
Position the stove and move
“A”
to touch the
wall behind the stove.
•
Mark the hole where
“A”
touches the wall
behind the stove.
All stoves can tilt if you or a child sit
or lean on an open oven door.
Safety regulations stipulate that the
ANTI-TILT mechanism supplied with
the stove, must be fitted as shown.
•
Move the stove away from the wall to allow
for an area to work in.
•
Using a 8.0 mm concrete bit, drill a hole at
the marked position.
•
Using the Stability hook and anchor sleeve
“B”
, firmly secure
“B”
to the wall.
•
Slide the stove back in position and engage
the stability chain
“A”
onto the Stability hook
“B”
.
•
The stove is then secured and will not
accidentally tilt if downward pressure is
applied to the open oven door.
Accessories supplied may vary depending on the model. Not all accessories in the user
manual may be included with your appliance. Accessories may be purchased from Defy
spares.
Fitting the removable splashback
Remove part
A
from the utility
compartment.
Remove all packaging material.
Line up holes on part
A
(Splashback)
to holes on part
B
(Hob panel)
Fasten panel
A
to panel
B
using the
screws, nuts and washers provided.
A
B
Anti-tilt mechanism
Page 3
